The VA800A-SPI is an USB 2.0 high-speed to MPSSE SPI Module, small electronic circuit board, utilising the FTDI FT232H. The 10-pin connector on the module fits directly to the FTDI VM800B and VM800C graphic display modules. This allows direct control of the EVE FT800 devices with an SPI interface from a USB host. All USB signalling and protocols are handled on the module. The VA800A-SPI MPSSE module is configured for SPI only. The 10-pin connector fits to the VM800B and VM800C graphic display modules directly.
USB 2.0 high-speed (480Mbps) and full speed (12Mbps) compatible
Entire USB protocol handled on the chip - No USB-specific firmware programming required
USB type-B micro connector
USB bus powered
Synchronous serial (MPSSE) data rates of up to 30Mbps on SPI
1kb receive and transmit buffers for high data throughput
3.3V level IO
Power indicator LED
SPI SS# active indicator LED
Adjustable receive buffer timeout
Support for USB suspend and resume
Low operating and USB suspend current
Low USB bandwidth consumption
UHCI/OHCI/EHCI host controller compatible
-40 to +85°C Operating temperature range
FTDI chip's royalty-free D2XX drivers eliminate requirement for USB driver development in most cases
(EN)
