The DS2431P+T&R is a 1024bit, 1-wire EEPROM in 6 pin TSOC package. This chip is organized as four memory pages of 256bits each. Data is written to an 8byte scratchpad is verified and then copied to EEPROM memory. As a special feature, the four memory pages can individually be write protected or put in EPROM emulation mode where bits can only be changed from 1 to 0 state. The DS2431 communicates over the single conductor 1-wire bus. The communication follows the standard 1-wire protocol. Each device has its own unalterable and unique 64bit ROM registration number that is factory lasered into the chip. The registration number is used to address the device in a multidrop, 1-wire net environment. The device is used in PCB identification, analogue sensor calibration including IEEE P1451.4 smart sensors, ink and toner print cartridge identification and after market management of consumables.
Reads and writes over a wide voltage range from 2.8V to 5.25V
Operating temperature range from -40°C to 85°C
Easily add traceability and relevant information to any individual system
Individual memory pages can be permanently write protected or put in EPROM emulation mode
Switchpoint hysteresis and filtering to optimize performance in presence of noise
Minimalist 1-wire interface lowers cost and interface complexity
(EN)
